Can i bury sprinkler wire

This wire is intended for field and central controls in underground sprinkler systems. I, personally, have discovered the use of thermostat wire, speaker wire, telephone wire, and even lamp cord in some systems. Two basic types of wire are generally accepted and approved for use in irrigation systems. Single conductor, solid core, or gauge insulated wire is widely used. Every valve has a solenoid with two wires; one common wire, and one zone wire.

If two zone wires are connected together at any point, they will both turn on at the same time. However, if a common wire is connected to a zone where the sprinkler timer is, it will fail. Many irrigation valve solenoids have an inrush current the sudden surge of current, measured in amps, occurring when the solenoid is first energized anywhere from.

When the valve is powered, the inrush current will reduce to a hold current, which has a lower amperage value between. Sprinkler wire is great. This wire is intended for drip systems, and will control up to four valves. It is rated for direct burial. A sprinkler works because the solenoid changes the water pressure inside the sprinkler chamber and lifts the plunger that opens the sprinkler valve. If your solenoid is bad, the water pressure in the sprinkler chamber will not be changed and the valve will fail to open.

This transmitter sends a signal down the wire the receiver handle can then pick up, allowing you to follow the path of the wire.

Some locators will tell you the depth of the wire as well. Using a standard extension cord is designed initially only for temporary use. Instead, you can use a more suitable cable type for any permanent outdoor purposes, such as a direct burial UF cable. In general, bury metal conduits at least 6 inches below the soil surface. You may also run them at a depth of 4 inches under a 4-inch concrete slab.

Under your driveway, the conduits must be below a depth of 18 inches, and under a public road or alleyway, they must be buried below 24 inches. Automatic outdoor sprinkler systems are a way to ensure that your lawn or grassy area remains green and vibrant all summer long with a minimum of effort on your part. Outdoor automatic sprinkler systems are usually operated with a number of different zones, or coverage areas, that are controlled by a main timer or other electronic controller.

Each sprinkler has wires running to it so that it will turn on and off when its zone is selected for operation. Correctly running the sprinkler wires to the various zone valves and sprinklers is the key to successful operation of your outdoor automatic sprinkler system. To run sprinkler wire, you will need to know the proper methods to use.

Use wire that has more hookups than you need. Often times you will only have three or four different zones in your automatic sprinkler system.

It only takes a minute to sign up. Connect and share knowledge within a single location that is structured and easy to search. I have a question about sprinkler wiring. The sprinkler timer is located on the front wall of my house this was done by the previous owner and I should run a wire from there to a sprinkler valve located in the backyard.

I was thinking of running the wire along the exterior wall, stapling it right below the roof. Then, when I read the articles of sprinkler wiring, most suggest to bury them under the ground. I am curious if it is ok to have over-ground wiring.

The total distance is about 70 ft. Ensure that the sprinkler wire you select is rated for UV exposure and a suitable temperature range for your region. Buried wire is generally protected from these elements by virtue of being buried. Either way, sprinkler system wiring is considered low voltage and there are very few codes governing the installation.

Being above or below ground shouldn't be a safety concern. Running the wire above or under ground is not the issue. The most important concern is to make sure the wire won't get cut or damaged by any means. Burying the wire is recommended, since it is hidden and not subject to damage from garden shears, nylon string trimmers, vehicle tires, foot traffic, etc. I have the timer in the garage; the valves are in two zones, one on the back of house, other are on the side.